Linear Gate Repair Nationwide

Linear Gate Repair in Houston: What to Know First

Linear gate repair in Houston covers the operator, the gate itself, and everything in between, and most jobs we see run between $95 and $350 for a standard service call. We’re an independent Linear service provider, which means we fix the operator and the gate as one system, and we typically complete most Linear repairs in a single visit because we carry common Linear parts on the truck.

Call (361) 256-5955

This page is for Houston homeowners with a Linear gate that’s stopped closing, started reversing for no reason, or sounds like it’s grinding through the morning. Call (361) 256-5955 and a live person answers, night or day.

How Linear Products Fail – and How We Fix Them

• Linear LRA and SLR series swing operators: capacitor failure after Houston heat cycles. The LRA and SLR swing arm operators use a start capacitor that degrades faster in sustained 95°F-plus heat with high humidity. The symptom is a gate that hums but won’t move, or moves halfway and quits. We keep replacement capacitors on the truck, and the fix usually takes under an hour. It’s one of the most common Linear repairs we make in Houston between June and September.
• Linear Pro Access and MegaCode receivers: moisture intrusion at the antenna connection. Houston’s morning humidity and afternoon thunderstorms push moisture into the receiver housing if the antenna grommet has dried out. The gate works fine from the keypad but won’t respond to a remote from more than ten feet away. We replace the grommet, clean the board contacts, and seal the housing edge before the next storm rolls through.
• Linear APeX and LDO series slide operators: limit switch drift from frequent cycle counts. These are workhorse slide operators, but the mechanical limit switches drift over thousands of cycles, especially on gates that cycle 40 to 60 times a day. The gate starts stopping short or over-traveling past the closed position. We bring the limits back to spec and check the rack gear engagement while we’re there.
• Linear LRA series: stripped drive gears after years of wind load. A heavy wood gate on a long swing arm puts constant back-pressure on the internal drive gear inside the LRA operator. We see this on older Houston homes where the original gate was replaced with something heavier than the operator was sized for. We replace the gear set and, when needed, rebalance the gate so the operator isn’t fighting the load.
• Linear MegaCode keypads: sun-faded buttons and cracked faceplates. The plastic faceplate on older MegaCode keypads gets brittle in direct Houston sun. Buttons crack, moisture gets behind the membrane, and the keypad starts throwing random codes or ignoring inputs. We replace the keypad assembly with an OEM or quality-matched aftermarket unit and reprogram it on the spot.

A note on parts: we use OEM Linear parts when availability and warranty status call for it, and we’re upfront when a quality aftermarket part makes more sense for an out-of-warranty operator. You’ll always know which one we’re installing and why before we touch anything.

Our Linear Gate Repair Process

1. 1
   You call, a person answers. That’s it. No voicemail, no callback queue. We ask what the gate is doing, what brand and model you see on the operator, and what time works.
2. 2
   We arrive, look, and listen. Before we open anything, we watch the gate run a cycle if it will. A Linear operator that’s grinding, clicking, or hesitating tells us a lot before the multimeter comes out.
3. 3
   We diagnose and write the price down. You get a written price for the repair before any work starts. No pressure, no “we’ll see when we get in there.” The number is on paper.
4. 4
   We do the work with the house in mind. Shoe covers go on if we step inside for a keypad or wiring run. Drop cloths go down in the garage or hallway. We use pet-safe lubricants where there’s a choice. If your kids are napping, we run quieter tools and skip the impact driver.
5. 5
   We test the full cycle, including the safety edges. A Linear gate that closes but won’t reverse off a safety edge is not done. We test obstruction reversal, force settings, and photo eye alignment before we call it finished.
6. 6
   We clean up and show you. We snap a photo of the cleaned work area before we leave and walk you through what we did. Every repair carries our 365-Day Done Right Promise. If it isn’t right, we make it right, no argument.

What Linear Gate Repair Costs in Houston

Most standard Linear service calls run between $95 and $350, and that’s the honest range Cody Beckman tells people on the phone. What moves the number is the part and the access. A capacitor replacement on an LRA operator sits around $160 to $240. A full keypad replacement on a MegaCode system runs $180 to $300 installed. A drive gear replacement inside an LRA operator with gate rebalancing can reach $450 when the gate itself is contributing to the failure.

Here’s the thing we want you to know: the price you see on paper is the price you pay. We don’t quote low and invoice high. Every estimate is free, and you’ll have the written number in hand before we turn a single screw. Call (361) 256-5955 for an exact quote.

Why Houston Homeowners Call Latch and Post Gate Repair Houston for Linear Work

We’re not a general handyman service that happens to see a gate once a month. Latch and Post Gate Repair Houston is part of the Cedarwell family of independently owned and operated gate specialists, and we’ve been doing gate work since 2009. Every gate comes down to two parts: the latch that holds it and the post that carries it. That’s the job we focus on.

Our technicians are background-checked, uniformed, and factory-trained on Linear, along with LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, so if the right fix means replacing a Linear part with something from another brand we carry, we can do it the same day. We lay drop cloths on the floor and put on shoe covers before we step inside. We ask before we move anything. We explain the price before the work. And we answer the phone when you call, 24 hours a day, 7 days a week. A gate that closes right is one less thing to think about.

FAQs